Coltene Pressure Spot Indicator

Coltene Pressure Spot Indicator

Coltene-whaledent

Availability: Sold out

Spot Indicator
New Rs. 3267

Rs.3,480.00

Rs.3,267.00

Description

Details

Coltène Pressure Spot Indicator is a silicone-based pressure spot material.

Type:

Polysiloxane, condensation-type silicone elastomer Type 2, medium consistency

  • Base: White
  • Catalyst: Green

The polysiloxane-based material for the location of high spots in dentures.

  • Recognition of pressure points on new or existing
  • partial and total dentures
  • Determining the need for relining
  • Testing of the exact fitting of inlays, crowns, bridges and cast brackets
 

INDICATIONS:

  • Recognition of pressure points on new or existing partial and total dentures
  • Determining the need for relining
  • Testing of the exact fitting of inlays, crowns, bridges and cast brackets

 

Coltène Pressure Spot Indicator is a silicone-based pressure spot material.

Type:

Polysiloxane, condensation-type silicone elastomer Type 2, medium consistency

  • Base: White
  • Catalyst: Green

The polysiloxane-based material for the location of high spots in dentures.

  • Recognition of pressure points on new or existing
  • partial and total dentures
  • Determining the need for relining
  • Testing of the exact fitting of inlays, crowns, bridges and cast brackets
 

INDICATIONS:

  • Recognition of pressure points on new or existing partial and total dentures
  • Determining the need for relining
  • Testing of the exact fitting of inlays, crowns, bridges and cast brackets

 

Features
  •  Polysiloxane
  •  Condensation-type silicone elastomer
  •  Low Viscosity
  •  Pressure Spot Material
Directions to use
  • Take up one component with spatula and spread evenly on the other component. Do not mix
  • First take up half of the mass in one go with the spatula
  • Then take up the other half of the mass in the same way
  • Using the flat part of the spatula, spread the mass on the mixing pad, spreading out to right and left with a little pressure.
  • Repeat steps 2–4 until a uniform shade is achieved

Impression

  • Coat interior surface and insert restoration. Hold in situ until the material has set completely. Remove restoration and indicate the pressure points with the enclosed marking pen (= interrupted layer)
  • Remove material and correct marked surfaces by grinding
  • Material residue needs considerably more time to set at room temperature
  • You should therefore check intraorally if the material is set before removing from the mouth. Intensive mixing, high temperatures or overdosage of the catalyst speed up the setting; low temperatures and underdosage of the catalyst slow down the setting

packaging
  • 1 x 75ml/70g
Additional Information

Additional Information

Dispatch Date 7-10 days
COD Yes
FAQs N/A
Reviews

Related Products

There are no products matching the selection.

Recently Viewed Products