Lentulo spirals are rotary paste carriers that spin root canal sealer or calcium hydroxide evenly along the canal wall. Mounted in a slow-speed handpiece, the flexible coiled wire drives paste apically as it turns. Waldent supplies latch-type lentulo spirals in ISO sizes #25 to #40 and 21mm working length, sold in packs of four.
Lentulo spirals are thin, coil-shaped rotary instruments that carry paste into a prepared root canal. Fitted to a slow-speed handpiece, the spiral turns and pushes sealer, calcium hydroxide, or medicament down the canal and against the walls. This spreads the paste more evenly than placing it by hand, in one quick pass.
A lentulo carries paste deep into the canal and coats the walls in a single pass. The coils grip the material and, as the spiral turns, drive it down towards the root tip. Two jobs make up most of its use:
Because the paste is spun in rather than pushed by hand, the coating reaches areas a hand file or plugger can miss.
Two numbers on the pack decide the fit. Match both to the canal you have shaped:
The sizing follows the same logic as the rotary files used to shape the canal — pick the spiral that matches the final prepared width.
A lentulo is fine wire, so it fatigues and snaps if it is pushed too hard. A few habits keep it intact:
Discarding a stressed spiral costs far less than retrieving a separated fragment later.
This category has one option right now:
The latch shank fits any standard slow-speed contra-angle, and the spiral sits alongside the sealers and pastes it delivers within the wider endodontics range.
A lentulo spiral is used to carry paste into a root canal and spread it evenly along the walls. Spun in a slow-speed handpiece, it drives sealer, calcium hydroxide, or medicament apically. It is used during obturation to coat the canal with sealer, and between visits to place an intracanal dressing.
Coat the coils with mixed paste, mount the spiral in a latch contra-angle, and run it slowly clockwise inside the shaped canal. Move it gently in and out while it spins, then withdraw it still turning. Keep the speed low and never force it, since a bent or over-revved spiral can unwind or fracture.
The size is the ISO tip diameter — #25 to #40 on this pack — and it should match the prepared canal width. The length, 21mm here, is the working length of the coils. A smaller number fits a narrower canal and a larger one a wider canal, so pick the spiral that matches how the canal was shaped.
Yes, a lentulo can separate if it is forced, run too fast, or used in a canal narrower than its size. The thin coil fatigues under strain and can unwind or snap. Using the correct size in a properly shaped canal, at low speed and light pressure, and retiring any kinked spiral, keeps the risk low.
The Waldent pack holds four latch-type lentulo spirals in ISO sizes #25 to #40 at a 21mm working length. The latch shank fits a standard slow-speed contra-angle handpiece. Buying a graded four-piece pack means the common canal widths are covered without ordering each size on its own.